Programming a Skylink garage door opener is a relatively easy process. The first step is to locate the program button on the garage door opener. In most cases, this button is located in the lower right corner of the unit. Once the button is located, press and hold it for at least five seconds.
The next step is to locate the remote control that was included with the Skylink garage door opener. This remote control should have two buttons on it, one for programming and one for operating the garage door. Press and hold the programming button for at least five seconds.
The third step is to press the program button on the garage door opener again. This will cause the remote control to begin flashing its LED light. When the LED light stops flashing, the programming process is complete.
The fourth step is to program each additional Skylink garage door opener that is to be used. To do this, press and hold the programming button on the remote control for at least five seconds. The LED light on the remote control will flash, indicating that it is ready to program another unit. Then, press and hold the program button on the additional Skylink garage door opener for at least five seconds. The LED light on the remote control will flash again, indicating that it is programmed to the new unit.
Finally, press and hold the programming button on the remote control again. This will cause the LED light to stop flashing, indicating that all of the Skylink garage door openers have been successfully programmed. It is now safe to use the remote control to operate the Skylink garage door openers.
Related Posts