“How to Repair a Garage Door Gap”
A garage door gap can be an eyesore, and it can also be a security risk if it’s large enough for pests or small animals to get through. Fortunately, repairing a garage door gap is a relatively straightforward job that any homeowner can do in a few steps. In this article, we’ll cover how to identify a garage door gap, how to measure the size of the gap, and how to repair it.
The first step to repairing a garage door gap is to identify it. This can be done by looking along the sides and top of the garage door and seeing if there is a noticeable gap. If there is, then you may need to repair it. The size of the gap is important, so you will need to measure it to determine how much material you need to fill it.
To measure the size of the gap, you will need to start at one end and measure the length of the gap. Then measure the width of the gap at its widest point. Make sure to record both numbers so you can purchase the right amount of material to fill the gap.
Once you have measured the size of the gap, you need to purchase the material to fill it. Most hardware stores carry weatherstripping or foam insulation that can be used to fill the gap. Make sure to get enough material to cover the entire gap, or it won’t be effective. If the gap is large, you may need to purchase more than one piece of material.
The final step is to install the material to fill the gap. This can be done with basic tools like a hammer, nails, and a utility knife. Start by cutting the material to the right length and then nail it into place. Make sure to press the material firmly into place so it forms a tight seal. Once the material is installed, you should have a secure and effective repair job.
Related Posts
