How To Adjust Electric Eye On Garage Door Opener Genie

How to Adjust Electric Eye on Garage Door Opener Genie

Electric eyes are essential safety features on garage door openers. They prevent the door from closing on objects or people in its path. If your Genie garage door opener's electric eye is not working properly, it is important to adjust it as soon as possible.

Materials You Will Need

* Screwdriver * Tape measure * Level

Steps to Adjust Electric Eye on Garage Door Opener Genie

1. Safety First

Before you begin, disconnect the power to your garage door opener. This will prevent the door from moving while you are working on it.

2. Locate the Electric Eyes

The electric eyes are usually located on either side of the garage door, about 6 inches above the ground. They are typically black or gray in color and have a small LED light on them.

3. Check the Alignment

Use a level to make sure that the electric eyes are aligned with each other. If they are not, loosen the screws that hold them in place and adjust them until they are level.

4. Measure the Distance Between the Electric Eyes

Use a tape measure to measure the distance between the electric eyes. The distance should be between 4 and 6 inches. If the distance is too short or too long, the electric eyes will not work properly.

5. Adjust the Sensitivity

The sensitivity of the electric eyes can be adjusted using a small screw located on the back of each eye. Turn the screw clockwise to increase the sensitivity or counterclockwise to decrease the sensitivity.

6. Test the Electric Eyes

Once you have adjusted the alignment, distance, and sensitivity of the electric eyes, it is important to test them to make sure that they are working properly. Place an object in the path of the electric eyes and see if the door stops closing. If the door does not stop closing, the electric eyes need to be adjusted further.

7. Reconnect the Power

Once you have finished adjusting the electric eyes, reconnect the power to your garage door opener. The door should now open and close properly.

Troubleshooting Tips

If you are having trouble adjusting the electric eyes on your Genie garage door opener, here are a few troubleshooting tips: * Make sure that the electric eyes are clean. Dirt and debris can block the sensors and prevent them from working properly. * Check the wiring. The wiring to the electric eyes can become loose or damaged over time. If the wiring is loose or damaged, it will need to be repaired or replaced. * Replace the electric eyes. If the electric eyes are old or damaged, they may need to be replaced.

Conclusion

Adjusting the electric eyes on your Genie garage door opener is a simple task that can be completed in a few minutes. By following the steps in this guide, you can ensure that your electric eyes are working properly and that your garage door is safe to use.